POE Injector Cable for CCTV Cameras Male DC and Male RJ45 to Female RJ45 Adapter Sometimes it’s hard to get power to your Ethernet devices. Wouldn’t it be convenient to use the same cable for power and data. Using these power over Ethernet adapters, you can do just that The complete Passive Power over Ethernet Kit contains two pieces – INJECTOR and SPLITTER. It is suitable for use with products that basically do not support Power Over Ethernet. Each cable has a female RJ45 on one side which is adapted to a male RJ45 and a 5.5×2.1mm barrel jack connector on the other side. The ‘injector’ cable has a female barrel jack connector and the ‘splitter cable has a male barrel jack. CAT-5-PASSIVE-POE-Power-Over-Ethernet-Injector-Splitter-Adapter Passive Power Over Ethernet SET is applicable for wide range of network products such as Access Points, Routers, IP cameras, modems, switches, embedded computers or other network devices. Featured by Sharvi Electronics The devices can be supplied standard power up to 50V. (The power adapter is not included – it is possible to use the power adapter of the powered device as an access point, IP camera, etc.) Passive PoE range is normally form 30-40 metres/100-130 ft (the real distance depends on the power supply, type of cable and powered device). CAT-5-PASSIVE-POE-Power-Over-Ethernet-Injector-Splitter-Adapter Simply attach the cables at each end of your network cable, plug the male barrel jack from the splitter into your target device and plug your desired power adapter into the injector. Featured by Sharvi Electronics Now you can use one cable to provide both power and data for your Ethernet enabled device. Complete set for wide range of network products such as Access Points, Routers, IP cameras, modems, switches, embedded computers or other network devices such as D-Link, Ovislink, Senao, Wline, D-Link, TP-Link, Linksys, Airtive, Senao, Wline, Micronet, Edimax, RouterBOARD, WRAP boards and other devices using passive POE injection.